Sentence examples for patch seal from inspiring English sources

The displacement was increased by 2 µm for each consecutive stimulation until the patch seal became unstable.

Mean on-cell patch seal duration in these conditions was 18±11 min. Initial seal resistance of 4.6±0.8 GΩ in room air was maintained under deoxygenated conditions at levels of 3.4±0.7 GΩ prior to seal loss.

nAChR responses were then characterised in voltage clamp mode at a holding potential of −60 mV, during which patch seal integrity was monitored by application of 5 mV, 50 ms hyperpolarizing voltage pulses every 60 s.

The authors suggest that a gelatin patch, sealing the tendon and carrying growth factors, could provide a better protection of the lacerated tendon ends from lubricin leakage and enhance the flexor tendon intrinsic healing [ 21].

At the same time, Mr. Saft said, while condominium bylaws usually provide that the unit owners are responsible for maintenance of repairs in their units, in this case the board should have patched, sealed and painted the wall to restore it to its original condition.

Qualitative imaging showed the annulotomy and nucleotomy successfully herniated NP material, while the HA NP injections restored intact NP morphology and the collagen AF patches sealed AF defects.

Making and breaking multiple loose-patch seals is an accepted and commonplace practice in many labs (1- 2).

In order to estimate the maximum current amplitude, we applied graded mechanical stimuli of increasing intensity until the patch clamp seal became unstable.

Assuming uniform surface density of Gardos channels, and between 150 and 300 copies per cell [37], [38], [39], we can estimate that up to about three percent of membrane area became accessible for current recordings within the domed patch upon seal formation.

Upon initial whole cell patch, a seal test and membrane test measured the following parameters: cell membrane capacitance (Cm), cell membrane resistance (Rm), access resistance (Ra), and holding current (I hold) necessary to keep the membrane at -65 mV.

Wash the walls, remove wallpaper, patch, spackle, seal stains, dry and sand before you attempt to paint.