Sentence examples for paste interface from inspiring English sources
XRD and SEM EDS analyses were carried out to characterize the mineral composition and textural morphology of the paste, interface and glaze of the samples studied.
The great absorption rate of aggregate lowers the water content at the aggregate/cement paste interface, and affects critically the mix design, and workability of fresh lightweight concrete.
Conventionally-designed concretes were prepared with different sand particle size distributions, so as to systematically vary the extent of aggregate-cement paste interface and the mean spacing between sand grains.
In addition, the effect of elevated temperature on the aggregate cement paste interface and aggregate microstructure of the concrete specimens was also has been examined by plane polarized transmitted light (PPTL) method.
This study demonstrated that nature of the aggregate and the w/c ratio conditions determines the micro structural characteristics of the aggregate cement paste interface and the mechanical properties of the ITZ.
A microscopic study on the plastic-paste interface was performed.
This may lead to crack formation along the aggregate-paste interface and, as a consequence, to a lower tensile splitting strength (Nguyen et al. 2011).
Due to better bond property between aggregates and cement paste than that between fibers and cement paste, the aggregate-paste interface is not the weakest link in LWC.
The SEM results showed that the crack width occurred at fibre-paste interface was smaller when compared to that at aggregate-cement interface, and the microstructure of cement paste around the fibres appeared more compact.
Pressure measurements from experiments without flow could show a marked offset from predictions with screws of low helix angles, this apparently being the result of an increased surface shear stress at the barrel-paste interface.
Find a simple and effective method to study the aggregate-paste interface is important to enrich our understanding of the role of aggregate, which occupy about 70% of concrete volume, on the microstructure of the interfacial transition zone (ITZ).
