Sentence examples for particles with poor from inspiring English sources

In contrast, the fragmentation of the support particles with poor swelling was hindered during ethylene polymerization.

Depositions under conditions yielding pure Sb coatings give rise to deposits composed of large crystalline particles with poor anode stabilities.

Magnetic separation of fluid cracking catalyst contaminated with nickel, vanadium, and iron enables removal of old inactive catalyst particles with poor selectivity from the more active and selective fresher catalyst particles.

By further use of Cloisite 20A nanoclay particles with poor disperse-ability in PLA, we also proved that a high degree of dispersion significantly promoted the cell density and the expansion ratio of the PLA nanocomposites.

In addition, the contact resistance of Au-PTFE/Ni-P coating is higher than that of Au/Ni-P coating as a result of the presence of PTFE particles with the poor electrical conductivity.

This refinement process fails, however, when a large number of particle images with poor SNR are used, that is, typical cryo-EM data sets of small molecules.

This evidence indicates that the risk in flow marginal zones could be underestimated by simply assuming that very thin distal deposits, resulting from PDCs with poor total particle load, correspond to negligible effects.

However, if the two drugs are loaded onto LP before PVP decoration, the formed particles tend to form microsized aggregates with poor colloidal stability.

While we cannot say whether or not the highest-energy particles were accelerated in the 12 CMEs with poor latitudinal connectivity, we can definitely say that there were no gigaelectronvolt particles in the three best-connected fast CMEs.

After storage, properties deteriorate due to ABS particle debonding and a polymer alloy is obtained with poor tensile properties.

The fill weight (1.5 21 mg) of group II powders (very fine and low dense particles with a particle size <10 μm, poor flowability and higher cohesion) depended also on the nozzle diameter (1.9 2.8 mm), the dosing chamber length (2.5 5 mm) and the powder layer depth (5 10 mm), albeit in a different way, indicating that for these powders dosator filling was not volumetric.