Sentence examples for particles in addition to the from inspiring English sources
The microstructure of ternary Zn 15Al Cu alloys containing more than 2% Cu revealed ε (CuZn4) particles in addition to the phases present in the binary alloy and the quaternary Zn 15Al 3Cu Si alloys exhibited silicon particles in addition to the phases present in the ternary alloys.
This paper is concerned with the development of constitutive models for particle-reinforced elastomers, which are designed to account for externally applied torques on the internally distributed particles, in addition to the externally applied deformation on the boundary of the composite.
A particulate matter with a mean aerodynamic diameter of 2.5 μm or less (WHO 2006), PM2.5 has raised close attention in East Asia due to its long-term negative health effects compared to other larger particles, in addition to the rapid growth of its presence in the past few years.
In the case of Fe3O4@Y2O3 Tb3+ composite particles, in addition to the characteristic diffraction peaks of the cubic Fe3O4 structure, there were obvious diffraction peaks indexed to the cubic phase of Y2O3 (JCPDS no. 86 1107, marked with ●), which suggests the successful crystallization of a Y2O3 Tb3+ thin layer on the surface of Fe3O4 particles.
EDS mapping of a biochar produced from corn stover pyrolysis shows individual sulfur-containing mineral particles in addition to the sulfur that is distributed throughout the organic matrix.
One of the SVFs tested was a calcium magnesium-silicate (calcium magnesium-silicateiosoluble fiber, for whiCMSthe stock preparation had a large concentration ofiber-fibrous parelatively addition to the fibiosoluble
To achieve the near-atomic resolution of the density map of the rotavirus inner capsid particle (2), in addition to the icosahedral symmetry, an additional 13-fold nonicosahedral symmetry was exploited for averaging (28).
The results demonstrated that mortar flow is directly dependent on particle packing, in addition to the uniformity index of the fine aggregate.
The results of the internal friction angle at different particle sizes were not exactly consistent with the results of the flow function, which could be a result of the different particle shapes in addition to the different sizes.
The EIS results obtained at the open-circuit corrosion potential have been interpreted using a model involving the impedance of particle to particle contact to account for the increasing resistance between zinc particles with immersion period, in addition to the impedance due to the zinc surface oxide layer and the electrical resistivity of the binder.
These results show that the particles in samples (1), (2), (3) and (4) are nearly spherical, with an average particles size dp of about 11 nm, but in sample(5) there are a few rod-shaped particles (shown in the insert) in addition to the spherical particles.
