Sentence examples for particle cut from inspiring English sources

An increase in the particle cut size with increasing solid concentration of the inlet mixture flow was observed and discussed.

The results thereof demonstrate that the positively bowed guide blade improves the classification precision and decreases the particle cut size.

Under certain feed conditions in the laboratory experiment, the separation efficiency of the mini-hydrocyclone was around 88% and the particle cut size d50 was 1.70 μm.

The pressure drop and particle cut-off performance of this quadru-inlet cyclone were experimentally characterized at various aerosol flowrates.

The study also demonstrates the non-linear relationship between particle cut-size diameter and pressure drop, implying that the cut-size diameter may approach an optimum size.

Powder that was above the specified 4.7 μm particle cut-off impinged on an air-water interface, and dissolution of salbutamol from controlled release formulations was evaluated using a flow through detector.

Although installing an extra guide-channel from the inlet may also improve the fine particle separation efficiency, it is not effective for particle classification because of reduced particle cut-size sharpness.

The sampling efficiency of such devices is affected by a combination of factors including intake air velocity, the shape and diameter of the airflow nozzles, the distance between the nozzle and the collection surface, the properties of the collection surface, the particle cut-off diameter, and collection times (Nevalainen et al. 1992; Whyte et al. 2007).

Comprehensive analysis of the SiC abrasive cutting reveals that when SiC abrasive particles cut at angle from 0° to 15°, cutting forces in along Y and Z direction are relatively small and tend to stay steady.

Fresh and healthy leaves were collected locally and rinsed thoroughly first with tap water followed by distilled water to remove all the dust and unwanted visible particles, cut into small pieces and dried at room temperature.

On the other hand, at the same simulation step, the larger the component speed along [001] direction, higher angle, deeper particles cut, and the more atomic lattices were destroyed.