Sentence examples for parameters were suggested based on from inspiring English sources

Appropriate deformation processing parameters were suggested based on the processing map, and were successfully applied in the quasi-isothermal canned forging of industrial-scale billets.

The CEB-FIP Model Code (MC90) (CEB-FIP 1993), which defined τ max as 2.0f c ′0.5, substantially underestimated the bond strength of steel bars in UHPFRC because the parameters were suggested based on test data from previous concretes.

The parameters of the design strength were suggested based on the mechanical test results of Ductal® (Orange et al. 1999), as follows: f ck  = 150 250 MPa, f tj  = 8 MPa, and E c  = 55 GPa, where f ck is the compressive strength, f tj is the post-cracking direct tensile strength, and E c is the elastic modulus.

In order to analyze the influence of configuration parameters on dynamic characteristics of machine tools in the working space, the configuration parameters have been suggested based on the orthogonal experiment method.

Concerning the mixing behaviour, thermodynamic parameters have been suggested based on the analysis of natural samples (e.g. Glynn 2000; Monnin and Cividini 2006) and theoretical calculations (Becker et al. 2000), and have been assessed experimentally [e.g. (Felmy et al. 1993)].

A conservative set of parameter estimates was suggested based on the upper 95% confidence interval parameters as a k of 0.3 yeand1 and a Lo of 100 m3/Mg if design is optimized and the lag is minimized.

In this paper, the importance of updating parameter selection is illustrated through a case study, and an automated procedure to guide the parameter selection is suggested based on simple observations.

A methodology that can classify the depth of drilling well based on the characteristics of the formation and drilling parameters has also been suggested based on the Bourgoyne and Young model to forecast drilling rates and the extent of bit abrasion.

In addition, key design parameters were derived and optimum operating conditions are suggested based on sensitivity studies.

A fault resistance model is suggested, based on Weibull distribution, which parameters are set per voltage level.

The determination of the wave-induced liquefaction depth is also suggested based on this non-dimensional parameter.