Sentence examples for parameter for the estimation of from inspiring English sources

The apparent dry density proves to be a very important parameter for the estimation of the water demand of the sand as well as for the influence of the sand type on the rheological and strength properties of the mortar.

The results of estimation using all the sets of various combination of meteorological parameter are analyzed and it is found that the sunshine duration is the prime parameter for the estimation of solar radiation.

The regression analyses indicate that the P-wave velocity is a very dominant parameter for the estimation of physical and mechanical properties of jet-grout columns and should be involved during the quality control of soilcrete material despite the intensive use of uniaxial compressive strength test.

Similarly, the root mean square acceleration (aRMS) is found to be the most efficient amplitude-related parameter for the estimation of maximum displacements in bilinear and CB structures whereas the peak ground acceleration (PGA) is the most efficient ground-motion parameter for the prediction of peak deformations in PR systems.

While the pI is a widely used parameter for the estimation of the electrostatic interactions of proteins, the prediction of the IER is frequently neglected.

In the ODE simulations, we introduced the memory length as the parameter for the estimation of the combinatory probability of the states.

F ST estimates and a UPGMA tree were used as starting parameters for the estimation of Θ and M. For each locus in the data set, the ML was run for ten short and three long chains with 10,000 and 100,000-recorded genealogies, respectively, after discarding the first 10,000 genealogies (burn-in) for each chain.

F ST estimates and a UPGMA tree were used as starting parameters for the estimation of Θ and M. The MCMC run consisted of ten short and two long chains with 5,000 and 50,000 recorded genealogies respectively, after discarding the first 100,000 genealogies (burn-in).

Wave height to water depth ratio and wave steepness were identified as the governing parameters for the estimation of runup height to wave height ratio.

ANOVA showed LoC and cutting force were more significant than other input parameters for the estimation of flank wear, and the design of fuzzy sets for input parameters was based upon this analysis.

Thus, estimated model parameters (λ, μ*, vF, ωp, τ, and ρ(0)) represent a good set of parameters for the estimation of normal state resistivity in alkali metal intercalated fullerides.