Sentence examples for overall sectional from inspiring English sources

We define the average of the data from the three sensors in the same section as the overall sectional temperature, and use the temperature difference between sensors at two different sections to calculate the temperature gradient.

Taking the average of measurements from the three sensors in each section as the overall sectional temperature in track slab, the relationship between the sectional temperature and the surface air temperature is shown in Fig. 4.

Normally, the thermal load can be divided into three parts (Fig. 1): the overall sectional temperature change, temperature gradient, and self-constrained temperature, which will cause expansion stress, warping stress, and inner stress, respectively [2].

The mean overall cross sectional area of the dural tube of all segments did not correlate with the objectively measured walking distance.

10 The overall cross sectional correlation between telomere length and age was estimated in cohort studies or controls in case-control studies.

The overall cross sectional odds ratio for poor self rated health was 1.04 (1.02 to 1.06) in binary logistic regressions (fig 1) and 1.08 (1.01 to 1.14) in ordinal regressions (see fig A on bmj.com).

n = 63, significance limit: p < 0.05 1) Test value from Mann-Whitney U test, otherwise Kendall's Tau B The mean overall cross sectional area of all segments- the number of segments measuring either less than 100 mm2 or less than 70 mm- as well as the smallest dural area of each patient were not found to have an influence on walking distance (table 3).

Overall cross-sectional rotations are defined and subsequently a correspondence of this complex problem to the simpler case of a homogenized shear-deformable nonlinear plate with effective stiffness and hard hinged boundary conditions is found.

This paper deals with modeling of the first damage mode (i.e. matrix micro-cracking) in helicopter rotor or wind turbine blades and how this effects the overall cross-sectional stiffness.

In a recent meta-analysis Dargél et al. (2015) demonstrated an overall cross-sectional association between BD and CRP.

From the XTEM images and using grid line method [16], it was found that during the rippling processes, the overall cross-sectional area of amorphous layer remains constant which validates the condition of incompressible solid mass flow inside the a-Si layer [13, 14].