Your English writing platform
Discover LudwigSuggestions(5)
Exact(1)
Orientations with the highest Schmid factors (0.45 0.5) for twinning display twin aspect ratios greater by ∼40% and twin number densities greater by ∼10 times than orientations with maximum Schmid factors for twinning of 0.15 0.2.
Similar(59)
The preferred orientation was taken as the orientation with the highest mean response in either attention condition.
For the measurements in the eastern part, there is no considerable match of fast orientation neither with the high-velocity nor to the low-velocity anomalies.
The source orientations with the lowest and the highest sensitivity were determined with the help of the singular value decomposition (SVD).
Determining orientation of key points: Using gradient-orientation histogram, each key point is assigned with an orientation at the highest gradient, thus determining main orientations of key points.
Regardless of whether tandem duplicates are removed or not, gene pairs with parallel orientation showed the highest degree of coexpression, in both average as well as median values, while gene pairs with convergent orientation showed the lowest degree of coexpression (Table 1).
On the other hand, TiN films with (111) preferred orientation possess the highest hardness [10, 12]. Figure 3 also depicts the variation of dislocation density, which represents the amount of defects and pores in the film.
Furthermore, we found that a wide necrotic lesion combined with a varus implant orientation caused the highest stem tip displacement, implying that a larger necrotic lesion with varus component placement is associated with implant loosening and implant failure.
We found that the spin anisotropy significantly affects the band structure of the antiferromagnetic configuration so that there are bands that are dependent on the spin orientation of the edge atom with the highest magnetic moment.
The Gd layer obtained at Vb = 150 V had a strong preferred (110) orientation and a dense structure with the highest residual stress (− 5.8 GPa) and argon content (∼ 3 at.%), while layers fabricated under zero bias or under Vb = 450 V had a strong preferred (002) orientation and a less dense structure with lower stress (≤ − 2 GPa) and lower argon content (∼ 0.5 1 at.%).
Here, the preferred MoS2 orientation corresponds to the one with the highest commensuration.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com