Different stoichiometries and monomer orientations were applied in these calculations.
Fingerprint image is tessellated into blocks, and Gabor filters with different orientations is applied on each block.
A 3-dimensional model was constructed and the calculated stress magnitudes and orientations were applied to the model.
To investigate the effects of in-situ stress on roadway stability, numerical models were built and high horizontal stresses at varying orientations were applied.
Moreover, response modulations following adaptation are constrained roughly around the adapter and the initial preferred orientations while the flanked orientations (all orientations being applied randomly) are unchanged through the recording sessions.
Next, algorithms developed to calculate properties of the entrapped nonwetting phase, such as volume, sphericity, interfacial area, and orientation, are applied to the residual nonwetting phase blobs.
A new technique is presented that uses two horizontal and vertical FE models to consider the concrete stiffness reduction of NPP buildings subjected to orthogonal ground motion excitations, in which appropriate stiffness reduction factors, based on the input motion orientation, are applied.
If the opposite orientation is applied (i.e. the negative direction in Fig. 2 is downslope and positive is upslope), then the calculated permanent displacements are larger.
The intensity gradient filter for vertical orientation is applied to four pixels (,,, and ) as shown in Figure 10(a) and calculated using the following equation.
It was found that if this optimal orientation was applied in Sulaimani, the inequity would have been reduced by 22% from III = 0.70 in 1955 to III = 0.92 in 2003.
