Sentence examples for orientation tolerance from inspiring English sources

Besides the material removal rate and surface roughness, the geometric measures such as overcut, form and orientation tolerance are included as performance measures in this investigation.

The proposed method is validated on a simple example of orientation tolerance and then performed to inspect the form defect on three large aircraft workpieces.

The solver determines the critical situation of the mechanism with respect to the contact constraints and the location and orientation tolerances.

Firstly, according to the accuracy requirements of the tool tip contour and tool orientation tolerances, the corner is rounded with a pair of PH curves directly.

While the linear displacement error of the table is quite low (4.5 μm), straightness, yaw and pitch errors on the other hand were significantly higher and may contribute from 20 to 30 microns of form and orientation tolerances over a large size build.

This orientation toward tolerance and respect has been superseded by an impatient and often abusive response to dissent.

This paper presents a model which predicts the part orientation error tolerance of a three-fingered robotic gripper.

All these results: the lack of clear orientation bias, tolerance to distance change and the lack of periodicity together seem to indicate that binding site interactions do not follow strict rules, at least in these tested cases.

NCP is known to yield an orientation of tolerance ellipses toward the participant's body (indicating an egocentric reference frame), but rotated slightly toward the arm used to perform the pointing gesture and toward the starting point of the movement [25].

Significant disturbances were found in motor behaviour, tone, poorer self-regulation capacities, higher excitability scores [ 144], poorer orientation, lower tolerance of handling and more stress in preterm infants compared with term born infants [ 73].

For each subject s, we compared the orientation of the tolerance ellipse computed from the sample Sa of n endpoints performed in condition a with the orientation of the tolerance ellipse computed from the sample Sb of m endpoints performed in condition b (n could be different from m due to outlier rejection from one sample or the other).