Sentence examples for optimum for the second from inspiring English sources

Interventricular optimization was performed using four different conventions for how AV delay is kept constant: Interventricular optimization with constant A-LV: Adjusting delay between the LV and RV while keeping the timing from the atrial lead to the LV lead is constant (120 ms for the first 11 patients, or the AV optimum for the second 11).

This plot compares the optimum SNR for the first CR, optimum SNR for each CR, and spatially varying SNR.

Daskin et al. (1992) studied future effects of uncertainty in DFLAPS conditions and the main aim was not to consider the location and relocation in time horizon but to find an optimum or near-optimum solution for the first period.

Using the theory developed here the optimum settings for the first dimension (1D) column can be derived.

The present investigation was undertaken to determine the optimum timing for the first and last irrigation of cotton on the basis of meteorological approach for scheduling irrigations.

Optimum design for the first example is equally supported at three points while the two-factor modifications of the Tait equation show designs with more support points than unknown parameters and different weights for each point.

Progress in the direction of more complex samples can be envisaged by implementing modulation and by reducing the gap between the (high) optimum flow rate for the second dimension in LC × LC and the (low) optimum flow rate of the nano-electrospray MS interface.

The MSE curves show that the performance of the optimal scheme is better than the sub-optimum scheme for the first iteration (i.e., initialization).

In both cases the optimum spacing between the second and third obstacles corresponded to the same optimum spacing found for the first two obstacles demonstrating that the optimum separation distance does not change with number of obstacles.

For case II, the non-cooperative scheme consists of two encoders C 1 = ℛ 2, 5) and C 2 = ℛ 1, 5) at the source node, and the optimum bit selection rule for the second encoder is λ o  = λ 1 also shown in (20).

After an optimization procedure, the second optimum for the tangential forces was found to be very close to the best optimum for the median defect area.