Sentence examples for optimized power density from inspiring English sources

It is also found that a higher optimized power density is available from a smaller control area.

Figure 9 shows the optimized power densities and voltages against current densities for cases of operating temperatures from 25°C to 75°C.

Furthermore a new design technique to produce an optimized surface power density distribution is detailed.

The optimized average power density of the CS-TENGs is proportional to the rotation speed (~ 0.41 to ~ 1.13 μW cm−2).

The optimized average power density of the RF-EMGs is proportional to the square of the rotation speed (~ 0.11 to ~ 2.25 μW cm−2).

While operating at low frequency near the resonant frequency of about 2.9 Hz, the device integrating 38 TENG units shows high output of transferred charges per cycle of 15 μC, short-circuit current of 187 μA and optimized peak power density of 13.23 W m−3.

In the present study, serpentine flow channels were considered, and dimensions of channels and current collection ribs were optimized for obtaining high power density under the same other conditions.

It was found that the optimized GDLs exhibited a power density of 487 mW/cm2 (H2/Air, 70 °C, 70% RH,) and 995 mW/cm2 (H2/O2,70 °C, 100% RH) for the optimum composition of 73% PB and 34% PTFE.

Laser power density was optimized to obtain full penetration joints without damaging the backing material.

Peak power density of the optimized cell is 112 mW cm−2.

The maximum power density response was optimized using a central composite design (CCD).