Sentence examples for optimization of flow from inspiring English sources
The influence of gravity on the optimization of flow configuration is also addressed.
The present paper is a first study in the direction of topology optimization of flow networks.
A new design of a cost-effective single pass gridded solar air heater (SAH) is presented featuring the optimization of flow resistance, mass flow rate, and efficiency.
The experimental protocol represents a design tool for onshore and offshore drilling operations that involve SBFs, with potential improvements on optimization of flow systems and cuttings transport efficiency.
Gradual change of dialysis pH, similar to that occurring in the gastrointestinal tract, was obtained by optimization of flow rate and concentration of NaHCO3.
The method illustrated in this paper – the thermodynamic (constructal) optimization of flow geometry – is applicable to any system that runs on the basis of a limited amount of fuel (exergy) installed onboard, e.g., automobiles, ships, portable tools.
Present work concentrates on improvements in the fuel cell performance by optimization of flow-field design and channels configurations.
Through appropriate machine selection under consideration of the respective hydraulic boundary conditions and, if required, in association with a mechanical optimization of flow-guiding components (e.g., smoothing the surface of impeller and casing, reworking of the impeller's geometry), PAT-efficiencies in the range of 80%% are feasible.
Optimization of flow-sorting parameters should increase the likelihood of capturing individual viruses.
The design of the gas turbine combustor is calculated based on optimizations of flow configuration (co and counter current), shell side and tube side (feed and sweep) flow rates, inlet fuel concentration in the sweep flow (CH4 plus CO2), and membrane tube diameter, pitch (spacing) and length.
By design of experiments (DOE) methods and an adoptive simulated annealing (ASA) optimization method, an optimization model of flow channel section design for hydroformed metal bipolar plate is proposed.
