Sentence examples for optimal efficiency for from inspiring English sources

"If you have perfect spectral matching between your heat source and your PV diode, you'll get optimal efficiency for the overall system," he says.

One of the key conclusions from this analysis is that while the optimal efficiency for regenerative CLC cycle was the highest of the three (56% at 3 bars, 1200 °C), the combined-regenerative cycle offers a trade-off that combines a reasonably high efficiency (about 54% at 12 bars, 1200 °C) with much lower gas volumetric flow rate and consequently, smaller reactor size.

Light modules (LM) must provide sufficient photosynthetic photon flux for optimal efficiency of photosynthetic processes and also meet the constraints for power, volume and mass.

F1 progeny was transferred to 29°C at late pupal stage for optimal efficiency of the UAS/Gal4 system.

The F1 progeny carrying both the UAS construct and the Gal4 driver were raised at 18°C until 3 days of adult development and then transferred to 29°C for optimal efficiency of the UAS/GAL4 system.

The threshold cycles (CT) were adjusted for an optimal efficiency of 2. The amplification protocol consisted of an initial denaturation step for 3 min at 95 °C followed by 40 cycles of denaturation (95 °C for 15 s), annealing, and elongation (61 °C for 20 s).

The point is that speed regulation cannot be ensured in optimal efficiency conditions, for a wide range of speed-set-point and load torque, unless the magnetic circuit nonlinearity is explicitly accounted for in the motor model.

Tune your kd-tree layout for optimal efficiency (minimize storage, improve layout for cache performance, etc).

Optimal efficiency investment strategies for some end uses vary significantly (in excess of 100%) between Pittsburgh and Austin, suggesting that resources and guidance conducted at the national scale may mislead state and local decision-makers.

A distinct dispersion of efficiency values and decline from optimal efficiency was observed for the Wizard extraction.

To test each probe for optimal efficiency, a second plate is designed for each target to enable the testing of various concentrations of each probe ranging from 25 nM to 225 nM in the presence of optimal primer concentrations (as established by plate 1 in each case).