Sentence examples for onset of dissolution from inspiring English sources

These implant sites represent initiation sites for the onset of dissolution processes.

Onset of dissolution of the hydrogel-based layers started after 300 min in a simulated wound milieu for the genipin-supplemented patch compared to 20 min for control and alginate/chitosan patches.

The onset of dissolution for SIMFUEL and the doped specimens was initiated by tetragonal distortions of the cubic matrix and was accompanied by a deeper more extensive oxidation of the UO2 matrix.

We used vertical scanning interferometry to examine the texture of the calcite surface produced by the experiment and the results suggested that at far-from-equilibrium conditions, the measured calcite dissolution rate was independent of the initial defect density due to the development of a dynamic dissolution pattern which became steady-state shortly after the onset of dissolution.

We present a linear stability analysis to study the growth of convective instabilities and determine the onset of convective dissolution and the initial wavelength of instabilities.

This comparison shows that the threshold for the onset of anodic dissolution (−400 mV versus SCE) is not noticeably changed by this increase in temperature.

The results show that an n-alkane carbon number range between 7 and 9 leads to earlier onset of convective dissolution, which is in agreement with the results of reservoir simulations.

Before the onset of homogeneous dissolution, variation in porosity follows a power-law behaviour with change in permeability when the latter is scaled by the concentration of the reactive species.

Quantitative data on the kink dynamics were obtained by an alternative approach (TOW-STM) and show pronounced local dissolution/redeposition fluctuations at the individual kinks even at the onset of Cu dissolution with average kink propagation and reaction rates at kinks in the range 103 and 105 atoms s−1, respectively.

A deeper observation over the evolution of conductivity reveals a break point which seems to be the onset of partial dissolution of the polymer.

The onset of relevant Cu dissolution was found to be around 0.9 VRHE, independent of the composition.