Sentence examples for only normal stress from inspiring English sources

Depending on the grain boundary distribution, the polycrystalline structure can result either in a more reliable structure or a less reliable structure compared to a single crystal structure when only normal stress based delamination is considered.

The equation is described as follows: Δ p = − γ ∇ · n ^ = 2 γ H = γ 1 R 1 + 1 R 2 Under the condition that only normal stress(in the absence of tangential stress) is considered, Δp is the pressure difference across the fluid interface, y stands for the wall tension, n ^ is the unit normal pointing out of the surface, H is the mean curvature, and R1 and R2 are the principal radii of curvature.

For only the normal stress, the stress on the biomimetic disc is 22.64% lower than that on the conventional one.

A new class of fatigue criteria extended from classical ones with stress gradient terms introduced not only in the normal stress but also in the shear stress components, is formulated.

CPT considers only changes in normal stress, which is modified by the pore pressure of the injected fluid.

A two-dimensional (2D) analytical method that is capable of providing an explicit closed-form solution is presented for the prediction of elastic stresses in balanced single-lap adhesive-bonded joints, assuming only a longitudinal normal stress linear distribution in the joint thickness direction.

Notice that no averaging is necessary for (lambda _{R}) because it is used only for updating the normal stress components.

In the case of level ice, an increase in normal stress only resulted in a small increase in shear resistance, when enough time was allowed for the clay to consolidate.

It is shown that the homogeneous plastic deformation ability of the tube before necking occurrence has hardly any dependence on the normal stress, which only influence the fracture morphology and fracture strain on the crack.

Indeed, models of rate-and-state friction assume an effective normal stress of only a few to several tens of MPa, in order to reproduce slow slip events with recurrence intervals consistent with those of SSEs (e.g., Liu and Rice 2007, 2009).

Fatigue life calculations account only for the normal stresses due to bending and centrifugal forces, neglecting the contribution of shear and transverse normal stresses.