The life cycle of an ON consists of four phases: suitability determination, creation, maintenance, and termination.
A diamond stylus profiling instrument was used to measure surface roughness on four phase I shearing facets of upper molars.
It is based on two phases: one offline, where reconfigurations are planned and organised; and another online, that takes advantage of such organisation of reconfigurations to autonomously choose one and adapt the system, as part of a monitoring feedback loop.
The Mobility-centric approach for Data Dissemination in Vehicular networks (MDDV) protocol[13] is based on two phases.
For electrical drives based on three phase PMSM, a way to improve the reliability is to allow a degraded mode operation on two phases only, thanks to specifically developed power and control architectures.
Research roadmap, based on process integration approach, is divided on six phases, and the primary tool used for the design of heat recovery network was Pinch Analysis.
The proposed approach is mainly based on three phases namely; a parameters learning phase, a simulation phase and a selection phase.
Another way to further enhance the performance of foam concretes are inorganic foams based on three phases which provide strengthening through pozzolanic reaction.
As mentioned below, the speech analysis algorithm is based on two phases: an LP analysis to obtain p LP coefficients, a i (i = 1, …, p) and a pitch analysis phase to extract the pitch gain g and the pitch delay d.
This approach relies on two phases: an offline phase for the MEMS and its degradation modeling, and an online phase where the obtained degradation model is used with the available data for prognostics.
