Sentence examples for of typical dimensions from inspiring English sources
To provide background, an overview of typical dimensions and uses of paperboard tubes in industrial, construction, and structural applications is provided.
A microfabricated rectangular duct (of typical dimensions: height 75 μm, width 500 μm and length 3 cm) was constructed using FOTURAN glass and standard photolithographic procedures.
Finally, practical information about the physical dimensions of typical dimensions for humans (male and female) is tabulated to help with the internal design of fuselages and cabin area.
For design purpose, a model office room of typical dimensions was chosen and its electrical energy consumption under prescribed conditions was evaluated over a year by means of computer simulation.
Experiments were conducted with silicon cantilever coated with gold (silicon micro-cantilever with gold coating of typical dimensions: LC × WC × TC = 400 × 100 × 0.6 µm3, coated with 2-nm Cr adhesion layer and 20-nm Au layer, resonant frequency: 5.3 ± 0.1 kHz, and spring constant: 0.029 ± 0.001 N m−1).
Two types of calcite seed were used: powder with a specific surface area of 1.29 m2/g (reported by manufacturer; J.T. Baker) and single Iceland spar crystals of typical dimension 10 mm × 6 mm × 5 mm (Ward's Scientific).
Since the micro-structured reactor is composed of pillars of typical dimension 5 × 100 μm, a special washcoat method has been developed leading to the controlled deposition of a homogeneous γ-alumina layer of thickness <1 μm.
The estimated effective normal stress (> 200 MPa) may be achieved by a subducted seamount with a base width of 60 km and height of 4 km (typical dimensions of large seamounts) as shown by Schloz and Small (1997).
Most of the TB and some of the smaller grains with typical dimensions of only a couple of nanometers exhibit locally an enhanced tetragonality.
A silicon chip contained an array of eight cantilevers having typical dimensions of 500 μm in length, 90 μm in width, and 1.0 ± 0.3 μm in thickness.
The region of interest was 256×256 pixels, approximately 40 µm square, which corresponds to a sub region of our PC12 cells, which have typical dimensions of 50 80 µm.
