Sentence examples for of the shank from inspiring English sources

Song of the Shank (Graywolf Press) by Jeffery Renard Allen reimagines late 19th-century New York in a novel that investigates American identity.

When the groom at the other end of the shank stopped, the horses pawed the ground until it was time to go again.

Lightweight, Danforth, and plow anchors have long, sharp flukes that pivot around a stock at the bottom of the shank and bury themselves deeply into the bottom; these anchors are generally used for yachts and other small craft.

Appert's gets the fibulas from a plant in Sioux City, Iowa, that separates them from the rest of the shank and cuts some of them into two-ounce portions, using a saw developed by Mr. File.

To cut the ham into perfect slices for serving, grip the exposed end of the shank bone with one hand (if your prefer, use a clean kitchen towel); with the other, cut vertically -- perpendicular to the bone -- from the top of the ham until the knife hits bone.

The shank of the tap has a reduced diameter that allows the tapped nuts to slide up the shank after they are tapped; the nuts keep the tap centred and they slide off the end of the shank and are ejected from the machine.

Cut gashes across the grain in the meaty part of the shanks and rub the paste into the gashes.

An Extended Kalman Filter (EKF) approach is chosen to estimate muscle dynamics parameters and to obtain full state estimates of the shank-quadriceps dynamics simultaneously.

Traditionally, the stiffness of the shank-chuck-tool system is so limited, whereas the semi-finishing and finishing machining of the dies and molds characterized by large-scale and deep cavity still mainly depends on electrical discharge machining (EDM) and manual polishing which will result in low efficiency and poor quality and cannot meet the needs of an increasingly competitive market.

The study demonstrates the influence of design construction of the shanks to its durability.

Many types of 3-D neural probes have been developed; however, most of them were designed as an array of multiple shanks with electrodes located along one side of the shanks.