Sentence examples for of lower thickness from inspiring English sources

The mechanical hardness of the top NiTi layer of lower thickness was found to be highly influenced by underneath PZT layer.

The interest for this material is due to indisputable advantages in term of insulation performance both for new and refurbished buildings; mainly in retrofit design, adoption of lower thickness assure same results with less invasive interventions.

This means that the transition of the PEG brush to a less solvated state of lower thickness starts at a significantly lower temperature than what is observed for free PEG in the same buffer.

The shift of the plasmon peak for lower thickness of Au was observed.

Higher coercivity (Hc) for lower thickness of Co layer confirms the formation of domain wall pinning.

They claimed that O3 was an important factor in high-quality ALD deposition, which resulted in the deposition of uniform, lower thickness (~5 nm) of dielectric layer without the S O bonds generation at MoS2 surface and the improvement of growth rate [57].

The degree of protection from the chromate film, in spite of their lower thickness, was detected to be higher for the alloyed samples.

The thickness of coatings plays a major role in deciding the life of coatings as lower thickness does not provide complete protection and higher thickness causes to reduce the coating life due to adherence problems.

In case of multilayer with lower thickness nanocrystalline layers, the band gap shifts toward higher values (1.64 eV to 1.72 eV) on increasing hydrogen dilution from 2 to 4. This can be justified on the basis that intermediate nanocrystalline layer deposition time is only 1 min (Table 1).

In both the IS and control subjects, the growth plates of Risser grade 2 subjects showed significantly lower thickness, area of cell-nest, number of cells in the cell-nest in the hypertrophic zone, and number of chondrocytes in the proliferative zone compared with those of subjects with Risser grade 0 and Oxford stage 2 3.

The fact that the tensile strength of BC produced in glucose-based medium was lower than that of BC produced in hydrolysates is perhaps due to the lower thickness of the BC pellicles from the hydrolysate media.