Sentence examples for of joint maximum from inspiring English sources

Consider detection error probability of joint maximum- likelihood receiver.

Unfortunately, this diversity advantage comes at the cost of having to rely on joint maximum likelihood detection (MLD) at the receiver.

One example of this is joint maximum likelihood estimation in IRT where estimates of ability are used to estimate item parameters (and vice versa).

Amino acid positions in the gene clusters that were presumably subjected to positive selection were identified by application of HyPhy selection test using joint maximum likelihood reconstructions of ancestral states under a Muse-Gaut model of codon substitution and Felsenstein 1981 model of nucleotide substitution as implemented in MEGA version 5.

Based on the parametric measurement of contact stress on the facet joint, maximum slip displacement of the implants on the endplate, and rotational angle of the upper vertebra in relation to the peak stress of contact site, the biomechanical differences of several implanted constructs were assessed under different loading conditions.

The algorithms defined for this kind of structures are based on a joint maximum likelihood (JML) estimation of the channel response and the frequency offset but with a very high complexity [30].

In the MIXjoint approach, the covariate data were added as dependent variables to the dataset and jointly analyzed in NONMEM based on a joint maximum likelihood of the nonlinear mixed-effects analysis of concentration data and the likelihood of observing the covariate data.

joint maximum-likelihood channel and frequency estimation.

The experimental results reveal that the fracture load of joint reaches a maximum of 31,076 N, and the joint fractures in C103 parent-metal when the overlap-length of the joint increases to 3.5 times the thickness of the parent-metal (3.5T, 7 mm).

It can be seen that the shear strength of the joint  was maximum at room temperature, were the oxide content of the alloy surfaces would ideally be at a minimum and would have good adherence to the aluminum alloy surface.

The different parameters are estimated by using the Maximum Expectation of joint Likelihood criterion.