Sentence examples for of identical weight from inspiring English sources

Based on those analysis, an optimal trapezoid origami crash box is designed to compare with the conventional square and octagonal tubes of identical weight.

Each decade, the Census Bureau calculates the mean center of population, determined as the place where an imaginary, flat, weightless and rigid map of the U.S. would balance perfectly if all 308,745,538 residents were of identical weight.

The Census Bureau describes it as "the place where an imaginary, flat, weightless and rigid map of the United States would balance perfectly if all 308,745,538 residents counted in the 2010 Census were of identical weight".

We prepared pooled samples by combining complete vertical sections of blubber samples (section weight range, 3.7 184 mg); small sample sizes prevented pooling of sections of identical weight.

Octacalcium phosphates (OCP, triclinic), Ca8(PO4)4(HPO4)2·5H2O, was obtained by hydrolysis, under stirring, of brushite crystals in the presence of an identical weight of ammonium hydrogenphosphate, at 37°C for 24 hours.

Depicted in Fig. 6 is a plate with sides (L_{a}), (L_{b}) and constant thickness h subjected to a sequence of moving loads with identical weight P and uniform interval (d_{text{v}}) ((d_{text{v}}) equal to vehicle length (l_{text{v}})).

Most significantly, although this approach maybe a little more time-consuming than the more common silane coupling reaction, in the present study the "long" arm may be produced in sufficient quantity such that all of the asymmetric stars are produced with long arms of identical molecular weight – the only remaining variable being the molecular weight of the short arm.

At this time, DQA has the same setup of threshold (tau) and initial values of (lambda) as that in the identical weight situation.

Figure 7 ExAssumeof nethatk graph and matconsistsnder the -hof inthoserence maximalin which the greedy algorithmatchinges no greater than of the optimal performance ( and ).

For both clones, drought stress increased the amount of the main RBCS1 isoform corresponding to spot 3 and also led to the accumulation of at least three other RBCS isoforms of identical molecular weight but different pIs.

The felt perception of differences in weights received experimental attention in 1899, when experiments indicated that a second weight feels either heavier or lighter than an immediately preceding identical weight.