Therefore, in order to obtain some valuable information for developing spray cut chrysanthemum with less-dispersed or non-dispersed pollen in the future breeding programs, we here investigated the factors affecting quantity of pollen dispersal of spray cut chrysanthemum with four cultivars, i.e. 'Qx-097', 'Noa', 'Qx-115', and 'Kingfisher', that have different quantity of pollen dispersal.
Three torch power levels were used for vacuum plasma spray to obtain different spray particle in-flight properties.
This requires higher spraying pressure to obtain the desired spray pattern inside the cylinder.
Based on the experimental results, the system parameters can be adjusted to obtain the desired spray characteristics, and areas of improvement on the design have been identified.
In order to obtain a spray-painting robot with the best performance, the 2-DOF 3-parallelogram PPM should possess the largest workspace and most stable transmissibility.
The source temperature was 70°C and the cone gas was N2 at a flow of 80 L/h; nebulizing gas was not used to obtain the sprays.
The solidification structure along peripheral to central regions of spray deposits, obtained using a spray atomization and deposition facility available at NPL in conical and flat disc shapes, has been evaluated.
A novel spraying apparatus was developed to obtain reproducible free sprayed films.
Experimental design is an effective method for conducting a reduced number of experiments in order to obtain the optimum spraying conditions and enhance the thermally sprayed coatings properties.
About 1 min spray time was obtained in paper spray using 40 μL of methanol, whereas more than 10 min spray time was available with only 5 μL of methanol in the extraction spray.
Given the flow rate, the spray cooling characteristics such as heat flux, critical heat flux (CHF) and spray efficiency were obtained under different spray chamber pressures.
