Sentence examples for numerical simulation parameters from inspiring English sources
Numerical simulation parameters are listed in Table 2.
Table 3 Numerical simulation parameters Oil rim recovery programme Gas injection period (months) Gas production period (months) Injection rate (104 Maximum Maxinjectionction pressure (bar) 0 55%% 8 (16 Mar. to 15 Nov). 4 (16 Nov. to 15 Mar).
The results show that solidification curves of single crystal superalloy vary greatly with several numerical simulation parameters and are particularly sensitive to the values of the heat transfer coefficient between the mold and test slab casting without core.
Table 2 Numerical simulation parameters Simulation parameter Medical nodes Non-medical nodes Information rates 2,4.2,4.4,4.8 kbps 5.4,7,8.3,10 kbps Processing gain 63 31 Slot length 10 ms 10 ms Symbol duration 2.0513 μ s 2.0513 μ s SIFS 75 μ s 75 μ s SYNC header duration 40.3 μ s 40.3 μ s PHY header duration 82.1 μ s 82.1 μ s MAC header duration 148 μ s 148 μ s PHY data rate 487 kbps 487 kbps.
Table 3 Computational conditions for present numerical simulation Parameter Value CNT Length (μm) 5 Diameter (nm) 50 Electrical conductivity (S/m) 1 × 104 CNT loading Wf (wt.%) 2, 3, 4, 5 Barrier height λ (eV) 1.5 Tunneling distance range (nm) Minimum value 0.47 Maximum value 1 Unit cell size (μm3) 25 × 25 × 15 CNT, carbon nanotube; Wf, CNT loading.
Many aspects have to be taken into account when springback reduction is investigated: material behavior issues, process conditions, numerical simulations parameters calibration, geometrical aspects and so on.
Fig. 11 Collision of two pulses from direct numerical simulation with parameters as in Figure 10.
After execution of a procedure based upon numerical simulation, optimum parameters for this model are found.
Fig. 10 Breathing instability from direct numerical simulation with parameters α = 5, β = 0.5, γ = 4, coupling strength g = 0.5 and Heaviside threshold h = 0.12 / ( 1 + g ).
Furthermore, with numerical simulation, working parameters such as punch force, the blank holder force, and the lubrication requirements can be determined without expensive shop trials.
Test results also gave some indications on numerical model simulation parameters.
