Sentence examples for numerical model indicates from inspiring English sources

Also the numerical model indicates a linear behavior between different pre-stressing forces and maximum tensile stress around the dowels.

Nevertheless, our numerical model indicates that EU-wide trade in green certificates may cut the EU's total cost of fulfilling the renewable target by as much as 70% compared with a situation with no trade.

The numerical model indicated that the most relevant loading scenario is when the resultant joint force is applied to the head at 8° from the diaphysis.

The results obtained from the numerical model indicate that modifying the source to exhibit dipole characteristics becomes more significant as the height of the barrier increases, and suggest that for any particular shape, absorbent barriers provide much better screening efficiency than the rigid equivalent.

Numerical modelling indicates post-glacial unloading as the main triggering factor of the slope deformation.

However, numerical modeling indicates that this is only the case for macro deformations and the extent of smaller displacements actually increases as a function of undercut depth.

Numerical modelling indicates that time-averaged and spatially averaged erosion rates in this region have been ∼0.5 mm a−1 since the early Middle Pleistocene, less than the regional uplift rates, indicating that the landscape is not in a steady state.

Numerical modelling indicates that such sealing timescale can be explained by the introduction of a fault sealing factor that allows modifying permeability with time and that is calibrated by the natural observations.

Numerical modelling indicates that erosion of surrounding areas at a typical rate of 0.2 mm a− 1 since 3.1 Ma could have caused this uplift, as well as constraining the local effective viscosity of the lower crust as ~ 4 × 1018 Pa s and the typical local Moho temperature as ~ 650 °C.

A series of scenarios simulated by numerical modeling indicate that the injection rate, injection depth and anisotropy of the aquifer are important parameters that need to be properly estimated to avoid critical thermal interference in shallow subsurface areas.

The experimental data and numerical modelling indicate masses extracted by SPME extraction are relatively small, with minimal perturbation on processes studied in diffusion experiments.