Sentence examples for noticeable attenuation from inspiring English sources

Live BoHV-1ΔgEβgal exhibits a noticeable attenuation, no virus was detected in nasal secretions during the post-vaccination period.

Model data and the single monitor scenario registered the largest attenuation in the regression coefficient, but there was noticeable attenuation even when using regional averages based on 5 monitors per 25 km × 25 km region.

WHR, BMI, and Gender had the highest correlations with the TC/HDL-C ratio (continuous or binary), with noticeable attenuation of the gender-specific correlations between WHR and TC/HDL-C.

Although a noticeable attenuation in the association between SD and LOS was seen after adjustment for hypoglycemia (reduction from 6.3 to 4.4% increase in LOS per every 10 mg/dL increment in SD), there was no significant change in the association between SD and mortality.

This concurs with the simulation findings of Sheppard et al. [ 12] who reported a "small but noticeable" attenuation in the heath effect estimate when ambient area exposure to PM2.5 was based on a single pollution monitor, but little if any attenuation when area exposure was based on the average across 3 or 10 monitors.

From the same graph it is noticeable that the attenuation for shorter wavelengths for a bend diameter of 20 cm is higher than for 10 cm.

Although there are minimal and hardly noticeable differences in attenuation due to the iodine contrast agent already present in the breast during the LE acquisition, the improved sensitivity was suggested to be attributed to a slight enhancement of cancers even on the LE images.

Thicker scattering layers are more likely to introduce signal attenuation, clearly noticeable in the bottom layer of phantom F. Occasionally the signal does appear to increase near the bottom of layers, as with the wS image of phantom D, but we attribute that effect to random intensity fluctuations induced by local scattering heterogeneity.

Second, all signal void regions overlapping with the mask were filled with a value representing the attenuation of soft tissue (0.1 cm−1), thereby assuming that noticeable signal voids in the dental region result from metallic dental implants only.

Applying the AGC in (14) and the extended noise reduction in (16) with the dynamic maximum attenuation in (32), this can be performed without noticeable switching artifacts within the signal characteristics.

It was found that the pseudo-strains induced by the attenuation of the diffracted beam were negligible, whereas there was a small but still noticeable effect produced by the attenuation in the incident beam.