Sentence examples for normal operating temperature from inspiring English sources
The samples were aged in an oven at a temperature above the normal operating temperature of a power transformer.
Low-power (1 Wthermal) Light Weight Radioisotope Heater Units have also been used to maintain spacecraft equipment within their normal operating temperature range.
ACI limits the normal operating temperature in concrete structures to 65 °C in general and 90 °C locally, as exposure of concrete to high temperature induces complex changes in the moisture content as well as chemical composition of the cement paste and mismatch in thermal expansion leads to internal stresses and microcracking in the concrete constituents (aggregate and cement paste).
Increasing the operating temperature by 200 K or more above the normal operating temperature (~1000 °C).
Ultimately, they settled on the idea of creating a polymer film that shut down its conductivity at a temperature above the normal operating temperature of a lithium-ion battery, but one that was still below the point where such batteries would catch fire.
Make sure you let the car get up to its normal operating temperature by driving or letting it idle for about 15 minutes.
In this paper, we extend our discussion to the effects of a dual-function MPL under subzero to normal operating temperatures.
This enables detectors to be made which offer good performance at higher than normal operating temperatures, and efficient negative luminescent devices to be made which simulate a range of effective temperatures whilst operating uncooled.
The effect on PEFC performance of a gas diffusion layer (GDL) with a hydrophilic layer (HL) between the microporous layer (MPL) and the carbon paper (CP) was investigated at high and low humidity at normal operating temperatures and at subfreezing temperatures.
At normal operating temperatures, the electricity readily passed through the film, allowing the battery to charge and discharge.
Some ITER members have insisted that the magnets must be tested at their normal operating temperatures before installation because a major fault could kill the whole project.
