Sentence examples for nominal cutting from inspiring English sources

If A d is the nominal cutting depth, then the uncompensated machining error changes the actual cutting depth of the nominal cutting tool position point into A d -δ and sets the deformation of the cutting tool in the radial feed direction which is ey and the nominal cutting width which is R d, so then the actual cutting width becomes R d -ey.

Here, the nominal cutting tool position is the programmed position which does not consider the deformation, and the actual cutting tool position is the deformed cutting tool position.

However, surface machining error is affected mainly by cutting depth, so the ultimate goal of an iterative solution can be converted to solve the actual cutting depth U n at each nominal cutting tool position point, so that the actual cutting tool position coincides with the nominal cutting tool position or meets the given convergence conditions.

Nominal cutting tool path T N will be sampled by a certain discrete degree p, according to the above iteration method to solve all sampling points to get the compensated cutting tool path T C. Figure 11 is a flowchart of the offline error compensation, where δ nj is the machining error of the jth sample points of the nominal cutting tool path after the nth iteration step.

The results showed that the surface contour machining error eventually converted to determine the radial deformation in the horizontal direction and the angle between the normal of machining workpiece surfaces and the cutting tool axis at each nominal cutting tool position point.

Milling parameters used in compensation processing example are as follows: spindle speed is 16,000 rpm, feed per tooth is 0.045 mm/z, nominal cutting depth is 0.3 mm, and radial cut depth is 0.4 mm.

It would oblige Argentina to continue trying to adjust its real exchange rate by deflation (cutting nominal wages and prices in nominal terms), a process which has already forced the collapse of many businesses.

Getting to the same point by cutting nominal wages would take much longer and inflict much more human and economic damage.

This would put euro-denominated borrowers into huge trouble, but the policy of sharply cutting nominal wages is gradually doing this in any case.

But by cutting nominal rates to prevent deflation, the Fed has reduced the real rate of interest too much.Evidence that this has been the case comes in two forms.

Moreover, although Argentine businesses cannot rely on inflation to reduce the real value of wages, anecdotal evidence abounds that a lot of firms have been cutting nominal wages during the current recession.