Sentence examples for nominal cross section from inspiring English sources

The characteristic time was found to depend linearly on the square of the nominal cross section.

The test parameters include the load eccentricity, the hollow ratio and the nominal steel ratio of the cross section.

One major reason accounting for this discrepancy is the potential loss of gold nanocages during sample preparation which was inevitable; thus the actual concentration could be lower than the nominal one, underestimating the overall cross section values.

Generalized Finite Strip Method (FSM) and Direct Strength Method (DSM) are combined to calculate the nominal compressive strength for a given cross section (a given design with a given set of turn angles).

The sensor captures the beam, converts the ultrasound power into heat and indirectly measures the spatial-average time-average ultrasound intensity (Isata) by dividing the calculated power by the beam cross section (or the nominal area of the transducers).

The nominal simulation uses a flux integrated cross section of 7.63×10-39 cm2 per nucleon with an average neutrino interaction energy of 1.3 GeV.

Combined wave overtopping and storm surge overflow of a levee with a trapezoidal cross section was studied in a two-dimensional laboratory wave/flow flume at a nominal prototype-to-model length scale of 25-to-1.

Throughout this letter, by 'areal density' we refer to quantities normalized using the nominal area of the inner wall (2Π r0d x for a differential slice) and not the cross section of the channel.

Based on S 0 cross section, we replace part of the upper subgrade layer with a 25 mm nominal maximum size (NMAS) dense-graded asphalt layer by considering five thicknesses of 10, 15, 20, 25, and 30.

The specific tensile strength and modulus were calculated because the pores in the cross section of the nanofiber mat do not give the true stress if the cross-sectional area is used for calculating the nominal stress.

Different insertion patterns along the multiple core cycles are investigated and differences against the standard cross section generation, which considers the control rods insertion only as a perturbation along the exposure in the nominal depletion sequence, are studied.