Circular samples of 27 mm diameter (nominal) and a maximum thickness of 2 mm can be accommodated.
In nominal GT load and maximum heat extraction they increase to 9.9 %, due to the higher condensate temperature, as described in "Combined cycle power plant".
The maximum stress on the outer surfaces can be expressed using the following equation: sigma_{text{max} } (x) = - k_{text{b}} sigma_{text{n}} (x) = - frac{{k_{text{b}} y(x M_{text{z}} (x)}}{{I_{text{z}} (x)}} = - frac{{3k_{text{b}} M_{text{z}} (x)}}{{2dy^{2} (x)}}, (13 where kb is the stress concentration factor for bending, σmax and σn are the actual and nominal maximum stresses, respectively.
The sample is excited by the air-cooled Rh target X-ray tube of ca. 100 μm nominal focal spot size and maximum power 75 W.
Cohesive zone model as well as two of its common initiation criteria, namely quadratic traction-separation criterion and maximum nominal stress criterion, are used to study crack initiation location and orientation under fretting conditions.
In this section, an algorithm for the automatic planning of the nominal power, P 0, and maximum UL cell load, U UL, on a cell basis is presented.
This paper evaluates the effects of break point (BP) locations and nominal maximum aggregate sizes (NMAS) on PA properties.
A total of 14 HMA mixes consisting of various types, gradations, and nominal maximum aggregate sizes (NMAS) were selected.
Permeability increased with air void content and nominal maximum aggregate size (NMAS); however, the effect of gradation was not conclusive as the primary control sieve point insufficiently defined gradation coarseness.
Two asphalt binders (PG 70-22 and PG 64-28), two aggregate types (limestone and crushed gravel), and two nominal maximum aggregate sizes (12.5 mm and 19.0 mm) were used in this study.
