The present study suggests that Ti and Si additions increase the stability of Nb3B2, and the primary region of Nb3B2 will appear in the Nb Ti Si B quaternary, while there is no primary solidification region of Nb3B2 in the constitute binaries and ternaries.
While many studies have shown better prognosis for the tip lesion and worse for collapsing FSGS, the true value of classifying FSGS based on morphology has been debated, particularly when it comes to collapsing FSGS which shows no segmental solidification but implosion of the capillary loops and podocyte proliferation instead.
The aspect ratio and the ferrite content for the DSS joints fabricated using the optimized ATIG parameters are found to be well within the acceptable range and there is no macroscopically evident solidification cracking.
The ECP has also no obvious influence on the solidification structure when it is applied during crystal growth, showing that the ECP cannot cause melting or break off the growing crystal.
If solidification is rapid, the solid-liquid interface is no longer in equilibrium, and it is generally accepted and has been demonstrated2 for solid solutions that this gives rise to reduced partitioning, in the limit leading to a solid having the same composition as the liquid through a process known as 'solute trapping'3.
No singular point is found for outward solidification.
While no defects occurred in the 4340/300M samples, solidification cracking was observed in the Aermet®100 multi-track clad samples, especially on 300M substrates.
However, when Ru was added in superalloy, the β-NiAl phase was firstly precipitated after the solidification of γ phase, and no fine γ/γ′ structure connecting the γ phase with β-NiAl phase was found.
No secondary-pollution problem will occur, because solidification of the arsenic is possible through arsenic concentrates incorporated into Portland cement.
There was no difference in the time required for solidification of FGS that did and did not contain TMZ.
