Sentence examples for multiplying the volumetric from inspiring English sources

b By multiplying the volumetric flow rate with the density of the pulse (taken to be equal to that of the surrounding air at the transitional level), it is possible to calculate the peak mass flux Q(t I).

The volumetric capacity is also an important consideration for practical application; that of the Bi2Se3/C electrode reaches 1064 mAh cm−3, calculated by multiplying the volumetric density of Bi2Se3/C (2.02 g cm−3) with the gravimetric capacity (527 mAh g−1) at 0.1 A g−1.

The measurement of d trans(t I ) and v trans allows us to estimate the mass flux of tephra Q(t I ) by multiplying the volumetric flow rate with the density ρ t and the volume fraction ϕ of tephra: Qleft {t}_Iright)={rho}_tcdot phi cdot {left(frac{d_{mathrm{trans}}left {t}_Iright)}{2}right)}^2cdot pi cdot {v}_{mathrm{trans}} (8).

Intracranial volume was calculated by multiplying the volumetric scaling factor with the intracranial volume of the standard MNI template.

Absolute volumes were estimated multiplying the volumetric density by the prostate weight [ 32] since the ventral prostate density could be considered as approximately 1.0 [ 33].

To determine the concentration of intact cells (and thereby account for possible cell loss due to fragmentation), we multiplied the volumetric flow rate in the flow cytometer by the time of analysis to determine the total volume analyzed.

The water volume was then multiplied by the volumetric heat capacity of water (4.2 MJ m−3 K−1) to determine the amount of energy needed to increase the temperature of water in the GHE by 1 K.

The net photosynthetic rate in the plant canopy was determined with the differences in CO2 concentrations between the inlet and outlet of the assimilation chamber multiplied by the volumetric air exchange rate of the chamber.

Quantitative calcium scores were calculated using the method of Agatston et al. (15) and by volumetric scores (acquired by multiplying the pixel area by the section thickness of the region of interest).

**Volume: volumetric measurement is obtained by multiplying the sum of areas from each slice with the reconstruction interval.

Ice multiplied the risks.