The re-usability and sharing of resources implies that the allocated registers and operators deal with multiple computational values which have different dynamic ranges and variable precisions.
Where there were missing data, we obtained multilevel multiple imputed values, which avoided the potential bias which can arise when incomplete data is mishandled (when cases are deleted, or when indicator variables are used for missing data).
For each MTB, we then counted the fraction of pairs having correlation values more negative than a certain threshold t, multiple values of which (from -0.1 to -0.7) were tested.
We then summarized all these correlations by computing the fraction of them more negative than a correlation threshold t, multiple values of which (-0.1 to -0.7 with a step size of 0.1) were tested.
Second, multiple repeated pressure values, which were less than the compressive strength values under the same confining pressure, were applied in dynamic triaxial creep tests at 60 °C, and the rheological numbers (FN) corresponding to the creep instability points of the asphalt mixtures were obtained.
These methods have serious limitations whenever multiple parameters have unknown values, which is usually the case.
Because complete case analysis in the setting of missing data may be limited by both reduced power and residual bias [ 23, 26], we performed a sensitivity analysis using multiple imputation of missing values, which provided results similar to our primary analysis.
Parametric optimization of the FE model can be used to reduce the vibroacoustic feedback in a device during the design phase; however, it requires solving the model iteratively for multiple frequencies at different parameter values, which becomes highly time consuming when the system is large.
Possible reasons include (1) spectral interferences on one or more isotopes during the analyses, (2) mass-independent isotope effects, or (3) complicated isotope fractionation processes characterized by multiple stages with different β values, which may have occurred during the production and purification of the Spec-pure Zn sample.
The insensitivity of cooperativity parameters led us to test a large set of different parameter values, which revealed that multiple parameter sets with different biological interpretations produced satisfactory correlations between the experimental data and the model output.
