Sentence examples for multiple switch faults from inspiring English sources

The results are presented for different fault configurations, single and multiple switch faults under variable load conditions at different frequencies.

But there exists a further scope of improvement and the need for new fault tolerant multistage interconnection networks, which can withstand multiple switch or link failures.

Finally, the results of multiple switching are also reported.

It should work with most standard light switches, although not two-way switches where multiple switches control the same light or lights.

For multiple switching, the bandwidth, buffer, and transition point management are similar to those of the single switching.

For multiple sensor faults, univariate fault isolation exhibits a significantly larger correct fault isolation rate.

This paper discusses the problem of fault diagnosis under multiple sequential faults occurrence.

Handling of multiple simultaneous faults is a complex issue in fault-tolerant control.

Each row in the table corresponds to multiple stuck at faults, either 2 or 3 faults noted by the net number.

Table 2 shows for a circuit with multiple stuck-at faults, the best drug selection for fault rectification (when possible).

In this paper, an innovated technique is revealed providing fault tolerance in the on-chip networks over single and multiple permanent switch failures.