Sentence examples for much lower strength from inspiring English sources

Attainment of height in concrete buildings progressed slowly owing to the much lower strength and stiffness of concrete as compared with steel.

It is important to distinguish between the high strength of a block of solid or intact rock and the much lower strength of the rock mass consisting of strong rock blocks separated by much weaker joints and other rock defects.

Under this assumption the remaining wall is constant and the predictive burst and collapse strength equations presented by standards are applied, but resulting in much lower strength values than the real case.

Classical ORT stress-strain response was significantly non-linear compared to the two multiaxial counter parts with much higher strain to failure and much lower strength.

Indeed the smallest detectable difference found in our study was established in healthy subjects and may not be a good criterion for detecting changes in subjects with much lower strength values as it can be noticed in our results (see Figure  3) that the difference between test and retest session is higher for higher strength values.

Large fibre reinforced composite structures can give much lower strengths than small test specimens, so a proper understanding of scaling is vital for their safe and efficient use.

Previously, we created bioactive silicate glass (13 93) scaffolds with a uniform grid-like microstructure which showed a compressive strength comparable to human cortical bone but a much lower flexural strength.

However, incorporation of GMS15 resulted in much lower specific strength values (only up to 13.64 kPa/kg m3) due to its thinner shell thickness and lower isostatic crushing strength value (2.07 MPa).

For the Ca3(PO4 2-added samPO4 2-addedmpresamplesthength is equivalent to that of the blank sample at 28 d, while the H3PO4-added sample exhibits a mucompressivemprestrengthrength over 28 d.

However, the specimens treated with an induction heating system at 1100 °C for 120 s had a much lower adhesive strength since a diffusion layer was not formed, leading to delamination of the entire coating from the substrate during the first stage of the fracture process.

However, GMS15 are not adequate to be used for such applications because of much lower mechanical strength associated with the resulting composites.