Sentence examples for much lower mechanical from inspiring English sources

However, GMS15 are not adequate to be used for such applications because of much lower mechanical strength associated with the resulting composites.

The secondary region corresponds to load levels below 7.8 MPa, and presents much lower mechanical strength reduction rates, indicating a tendency to stabilization of the curve.

There is evidence that glass fibre reinforced polymer (GFRP) pultruded profiles are particularly susceptible to transverse compressive loads, owing to the much lower mechanical properties in the direction transverse to the pultrusion axis.

There is evidence that GFRP pultruded profiles are particularly susceptible to transverse compressive loads, owing to the much lower mechanical properties in the direction transverse to the pultrusion axis.

The frequency at which the transition from lumped to distributed models takes place is much lower for mechanical filters than it is for their electrical counterparts.

In addition, due to definite advantage of robust rotor structure of DESF motor, rotor mechanical stress prediction at highest speed of 12,400 r/min is much lower than the mechanical stress in conventional IPMS motor.

By the time of writing, the maximum areal density of phase-change probe memory that can be achieved experimentally is up to 1 Tbit/in2 [94] with corresponding power consumption of 100 PJ per bit [95], much lower than the thermo-mechanical probe memory.

Mechanical property changes obtained at 15 MHz with the QCM were correlated with measurements at much lower frequencies utilizing traditional dynamic mechanical analysis.

The resulting design allows benefiting from the fast breaking and very low maintenance requirement of the static switches, besides maintaining the advantage of the much lower power losses of the mechanical bypass in normal operation.

After the presentation of the device design, fabrication and assembly, we demonstrate the good operation and reproducibility of the device (100% of success rate) with a response time much lower than that of classical mechanical circuit breakers, which are slow.

Along the axes perpendicular to the cavity axis, the mechanical frequency is much lower but the occupation in this direction should, in energy, also correspond to the occupation along the cavity axis.