Sentence examples for much lower adsorption from inspiring English sources

Our results show that untreated and oxidized MWCNTs have much lower adsorption than new synthesized adsorbent.

Compared with the cellulose fiber, the mineral fiber had a much lower adsorption and stabilization effect on asphalt, although it also had high specific surface area, mainly due to its smooth surface texture with a lubricant effect and low soaking effect.

On the other hand, Novozyme 188 β-glucosidase had a much lower adsorption capacity and affinity for all of these substrates than cellulase.

For single component solutions, the adsorption behavior of tyrosine was similar to that of phenylalanine, with the prepared sorbent presenting a much lower adsorption capacity for Tyr (14 mg g−1) than for Phe (109 mg g−1).

The adsorption behavior of tyrosine was similar to that of phenylalanine in single component solutions, however, with a much lower adsorption capacity (14 mg g−1 for Tyr compared to 109 mg g−1 for Phe).

However, when we consider the co-adsorption experiment, we find a much lower total adsorption (Table 2).

At the C W interface, where a low interfacial tension leads to a much lower surfactant adsorption, the contact between the phases is much greater.

Ordered structures such as nanowires should contain a lower density of such surface defects, but suffer from the low surface to volume ratio that leads to much lower dye adsorption capability.

The A-MWCNTs achieved a much lower CO2 adsorption capacity, and are thus not comparable with CNTs from literature and are unlikely to be suitable adsorbents for CO2 capture.

Hydrous Al oxides and clay minerals have a much lower affinity for adsorption of As III) than do amorphous and crystalline hydrous Fe oxides.

The isosteric heat of C2H6 and C2H4 adsorption on C-PDAs were much lower than the preferential adsorption affinity of olefin over π-complexation sorbents.