Sentence examples for ms in order from inspiring English sources

At the same time, TIMER2 and TIMER1B continues to generate square waves, while TIMER0 is evoked every 1 ms in order to provide a timer to provide functions, such as wait and debounce.

This signal is interrupted each 2 s during 10 ms in order to measure the junction and the dissipator temperatures.

In our simulations, we change n from 4 to 30 and set d= 5, 10 ms, in order to illustrate this observation.

Windows PowerShell was programmed to log the application's name every 33.3 ms (in order to keep up with FFmpeg logs, where we had one frame every 33.3 ms).

However, their position was randomly jittered by ± 16 pixels every 100 ms in order to reduce the effects of local light adaptation.

Very long simulations are needed (Last=1000, 5000 for pre-Hopf and pre-Turing cases, respectively) with very fine time steps (dt=0.005 ms) in order to obtain fully evolved patterns similar to Figs. 5 b-III) and (c-III).

We estimated the LFP power density during the presentation of the stimuli using sliding windows of ±150-ms length in steps of 10 ms. In order to obtain optimal spectral concentration, we used the multitaper method by multiplying each data epoch with the tapers before Fourier transforming (Mitra and Pesaran, 1999; Jarvis and Mitra, 2001; Pesaran et al., 2002; Womelsdorf et al., 2006).

The digits were presented randomly with a rate of one per second with a presentation time of 50 ms. In order to assess general cognitive ability, we administered the LPS3 (Leistungspruefsystem).

(3) Calcium traces were down-sampled to a final temporal resolution of Δt = 250, 167, or 88 ms. In order to simulate the lower signal-to-noise ratios for smaller Δt, which resulted from line skipping during in vivo imaging, we adjusted noise levels by a factor of √2 and √4 for Δt = 167 and 88 ms, respectively.

Two commercial soot samples are analysed by temperature programmed desorption mass spectroscopy (TPD-MS) in order to determine the functional groups at their surface.

Our test scenarios are primarily designed and optimized for two hops (BS-RS-MS) in order to achieve a high performance in terms of throughput and delay.