Different ESW treatment regimens were investigated: (1) an EFD of 0.11 mJ/mm and peak positive pressure of 31 MPa (number of shots = 300, 1,000, and 2,000, respectively; frequency = 4 shocks per second), and (2) an EFD of 0.22 mJ/mm and peak positive pressure of 90 MPa (number of shots = 300, 1,000, and 2,000, respectively; frequency = 4 shocks per second).
The horizontal stress difference is 3 MPa, the number of the perforation clusters is 4 and the cluster spacing is 20 m.
Therefore, T160M20PC-1 indicatespecimenen made with tube of diameter 160 mm, filled with plain concrete having compressive strength 20 MPa and number one.
Open image in new window Fig. 4 Test setup of plug processes Table 2 Test parameters Inner diameter of the test pipe, mm Outer diameter of the test pipe, mm Water density ρ water, kg m−3 Water viscosity µ water, kg ms−1 Inlet velocity w 0, m s−1 Test pressure P test, MPa Reynolds number Re 25 30 1000 0.001003 1 0.1 25,925.
The influence of the processing conditions, namely, the pressure of the high-pressure homogenizer (20 90 MPa), the number of passes through the homogenizer (0 4) and the evaporation temperature (16 66 °C) on the physicochemical properties of the prepared astaxanthin nanodispersions were evaluated using a three-factor central composite design.
The study was conducted as an investigator-driven clinical trial, registered online at EudraCT EU 2007-006539-29 [ 5] and at NCT00828997, and approved by the Swedish Medical Products Agency (MPA; file number 151: 2007/88047).
The study was conducted as an investigator driven clinical trial, registered on line with numbers EudraCT 2007-006539-29 and NCT00828997, approvedoved by the Swedish medical products agency (MPA; Läkemedelsverket; file number 151: 2007/88047).
The yield strength was 400 MPa and the number of specimens was three for each diameter.
PD and MPA describe the number and size of patches of tanglehead.
β-cylindrites can be observed by PLM in the extruded specimen even at a lower σw (0.020 MPa), and the number of β-cylindrites nuclei increases rapidly with the lowering of Te.
In contrast, the liz/ctl gouges deformed at P c = 100 to 170 MPa contain a number of anastomosing shear zones that are oriented subparallel to the gouge-rock interface (referred to as Y shears) and that are separated by intervening lenticular regions in which the grains are found to be more massive, sub-equant, and less deformed overall (Figure 7C).
