Sentence examples for mounted transversely to from inspiring English sources

In this paper, the effect of three synthetic jet pairs on the mixing between two fluid streams in a planar mixing channel is examined at a net flow Reynolds number of 2. They are mounted transversely to the incoming flow and operated 180° out-of-phase.

Cell-in-cell structures were examined under a laser-scanning confocal microscope scan head LSM510 NLO (Carl Zeiss, Göttingen, Germany) mounted transversely to the Axiovert 200 inverted microscope (Carl Zeiss) with a 40 × 1.3 numerical aperture PlanApo objective.

Started as an off-hours project by Dallara, Stanzani and Wallace, the Miura — one of several Lamborghinis named for fighting bulls — was a major departure because its V-12 was mounted transversely at the rear.

In the Maxima, the 152-horsepower engine is mounted transversely and hooked to the front wheels, and it is more than adequate.

Finding space for the extra seats wasn't the work of a moment, with the Freelander's MacPherson strut suspension replaced with a more compact multi-link set-up that fits beneath the boot floor, while the engines are mounted transversely rather than longitudinally (like they are in the Q5), enabling front seats to be further forward in the wheelbase.

And its engine is mounted transversely rather than lengthways.

The only engine is a 3.6-liter direct-injection 24-valve V-6 rated at an adequate 304 horsepower, mounted transversely alongside an easygoing 6-speed automatic transaxle.

An additional cross-beam, mounted transversely and with a movable mass at each tip, allows tuning of the primary torsion LNM such that it is close to the primary bending LNM.

The sedan has Honda's widely used 3.5-liter V6 mounted transversely in the front mated with a 47-hp electric motor and a seven-speed dual-clutch transmission.

With both brands, the standard drivetrain couples the transversely mounted powerplant to a five-speed manual transmission.

In order to demonstrate this, we induced a defect along the interface by positioning a piece of copper plate transversely to the guiding direction (Fig. 4h).