Sentence examples for moulding procedure from inspiring English sources

The results reveal that deteriorations in the mechanical properties of products produced from recycled plastic can be improved by optimizing the processing parameters during the injection moulding procedure.

Injection moulded specimens made from different compositions of virgin-recycled PP were tested to determine the optimal conditions for the injection moulding procedure.

In this paper, the Taguchi method and principal component analysis (PCA) are used to improve the mechanical properties of recycled polypropylene (PP) blends in injection moulding procedure, with detailed assessments performed on each method and comparison was made based on results of both the methods.

With the traditional methods (cf. [5], [11], [13], [14], [15]), numerous appointments with the doctors, moulding and fitting procedures are necessary before any prosthesis can be obtained.

However, much variation is observed in the properties of bricks and especially in its compressive strength, depending upon the composition of bricks and the manufacturing procedures (viz., moulding, pressing, firing, autoclaving, cementing, geo-polymerization etc).

The use of hearing aids can improve localization, but any benefit is highly dependent on the user's type and degree of hearing loss, mould-type, and fitting procedure (Byrne et al. 1992), with completely-in-the-canal aids offering a better localization benefit (Best et al. 2010).

The high strength and ductility values can be achieved without using the injection mould casting or rapid solidification procedure.

Design procedure of large blow moulding machine rack is discussed in the article.

This study proposes a procedure for digitally classifying and cataloging moulds which belong to the historic collection of the Ginori porcelain factory in Doccia (Sesto Fiorentino, Italy).

This paper presents a design procedure and cost analysis for a mould made of glass fibre reinforced polyester filled with copper particles (GRP/copper).

The FEA design procedure was also used to determine the mould thickness with a safety factor of at least four.