Sentence examples for moulding material from inspiring English sources

The protective materials studied included silicone based conformal coating, polyurethane based moulding material, and silicone based moulding material.

The results showed that conformal coating and polyurethane based moulding material markedly decreased the times to failures of the devices.

The design of the ejection system depends on factors such as the draft angles, the surface finish, and the properties of the moulding material at the ejection temperature and the dimensioning of actuation devices (e.g., hydraulic or pneumatic cylinders).

The existing slab track produces between 1·5 and 3 dB(A) more noise than the ballasted track; this is caused by resonances in the elastomeric moulding material in the frequency range determining the dB(A -level.

The study aims to understand the failure of adhesive joints within glass fibre reinforced plastic (GFRP) pultrusions and the effects of moulding materials on adhesion.

NMR measurements show that the amorphous phase in the powder is more constrained than that of the moulded material, and that the powder also has a fraction of monoclinic crystalline material associated with internal stress.

Matrix orientation patterns are different from those of the pure polymer moulded material and are mainly influenced by the fibre orientations, which are themselves affected by the processing conditions.

While it would be thought from DSC results that the powder has much thicker crystallites than the moulded material, it is shown quite clearly by nitric acid etching techniques followed by GPC that the crystal lamellae in both forms of the material have similar dimensions, close to 20 nm on average.

Compounded and compression moulded materials were evaluated using various techniques including thermogravimatric analysis, scanning electron microscopy, differential scanning calorimetry and dynamic mechanical analysis.

In this paper the effect of the protective coating and moulding materials on product level reliability of an electronics device was studied under thermal shock test.

Usually they crush it to powder and use it for medical moulding materials.