Sentence examples for most optimal condition from inspiring English sources
The results showed that the most optimal condition was at OD600 = 0.9, inducing the culture at 34 °C for 6 h with 0.1 mM IPTG (Fig. 5).
Correspondingly, the most optimal condition to perform such treatment was studied based on previous researchers, in which the alkaline medium used was 6% sodium hydroxide (NaOH), followed by 12 h immersion period.
Among all the tested nitrogen sources and concentrations, ammonium acetate of 3.5 g/L revealed to the most optimal condition for improving CHA production (32 mg/L) and was selected for further medium optimization in the subsequent experiments.
The results showed that pretreatment with 0.25% acetic acid at 191 °C for 7.74 min was found to be the most optimal condition for pretreatment of corn stover under which the production of acids can reach the highest level.
Pretreatment with 1% sulfuric acid and 20% solid content for 10 min at 180 °C was found to be the most optimal condition for pretreatment of rapeseed straw for ethanol production.
The most optimal condition was at OD600 = 0.9, inducing the culture at 34 °C for 6 h with 0.1 mM IPTG, which is consistent with previous reports that low temperature and low IPTG concentration may improve the solubility of target protein (Vu et al. 2016; Xu et al. 2006).
For melt-quenched PLLA, it was found that the most optimal conditions to introduce crosslinking were around 3% of TAIC and the irradiation dose of 50 kGy.
However, due to the chloro-organic compounds formed in the electrochemical oxidation with NaCl, the TOC removal in the most optimal conditions was approximately 93%.
According to the results, the most optimal conditions for removal efficiency of acetamiprid (pH = 7.5, contact time = 65 min, and dose of nanoparticle 550 mg/L) was obtained at 76.55%.
An overview is given of the detergents and disinfectants available, the most optimal conditions (temperature, detergent concentration, flow rate and water quality) for cleaning, and the most optimal CIP system designs allowing cleaning without contamination of food products.
In accordance with the results of experiments, the most optimal conditions considered for Ni/NiO nanopowders obtained by thermal decomposition of nickel acetate ammines were ammonia concentration in initial complex 9.55 mol /mol Ni2+, annealing temperature of 350°C, and duration of 60 min.
