Sentence examples for mortars were compared from inspiring English sources

Microstructures of these polymer-modified mortars were compared and discussed.

A conventional mortar was compared with ones incorporating rubber tyre particles, partly replacing the natural sand aggregates.

In this section, the results obtained by two different techniques (nitrogen adsorption and water adsorption) on the same material (CEM II mortar) are compared.

The influence of the addition of both types of fibre on energy absorption and tensile strength at high strain-rate was investigated, and the performance of the two types of fibre-reinforced mortar was compared.

In this study, an infilled masonry wall and a similar Sassanid era arched masonry wall, both with clay bricks (square bricks of 195 mm long) and clay and gypsum mortar, are compared and their seismic behaviors are tested under cyclic loading (as per protocol).

The main novelty of this work lies in the fact that this is the first time that two types of mortar are compared in the repair of four column sides, in addition to the possible use of bonding agents between the mortar and the column.

The experimental results of mortar with CBBA were compared with those of mortar with raw bottom ash, and with artificial lightweight aggregates.

Mechanical, physical and rheological properties of mortars comprising LAS were compared to ones with commercial admixture and one without any.

Measurements were made on rising damp on walls made from different mortars and the observations were compared with theoretical models.

The results were compared with ordinary mortar (without addition) and mortar containing 10%% of silica fume.

Additionally, at the end of 3 years of exposure, residual flexural strength, compression strength and ultrasonic pulse velocity (UPV) of mortars were determined and their results were compared with the reference samples which do not contain mineral additives and cured in water.