Sentence examples for more homogeneous composite from inspiring English sources

SEM analysis showed better fiber wetting by resin on UR groups), resulting in greater homogeneity, as seen by fiber and resin distribution in the composite; the more homogeneous composite seemed to enable an "easier" interaction between resin and fibers and consequently better protection against fracture development).

The obtained decrease in porosity content results in a more homogeneous composite and better fibre matrix adhesion.

The excess of particle surface charges upon SDS adsorption is pointed out for a better stability of the corresponding ink formulation as well as for a better dispersibility of the powder at dry state, which result in a more homogeneous composite electrode.

The amorphous manganese oxide nanocrystals show better anode performance with greater discharge capacity for lithium ion batteries than does the well-crystallized K0.45MnO2, which is attributable to the greater surface area, higher structural and electrochemical stability, more homogeneous composite structure, and better charge-transfer characteristics of the amorphous materials.

As we mentioned above, moderately prolonging the reaction time may promote the bonding of BaCrO4 on graphene with Ba-C chemical interaction, leading to the formation of more homogeneous composites, and better linkage between the two materials must facilitate the electrons transfer, causing more decrease of emission [23].

In hybrid composites two or more reinforcement materials with different properties are mixed at molecular level in continuous metal matrix phase and these composites are more homogeneous than the traditional composites and offer improved properties.

The thermal conductivity of binary molten salts was enhanced by 4.9 6.9 times after impregnation with EG. SEM photographs showed that the prepared composites were more homogeneous in comparison to other salt/EG composites prepared by infiltration or compression.

Some localized clustering of SiC particles was observed in as-cast composite, whereas a more homogeneous distribution of the SiC particles was achieved in heat-treated composite.

It should be pointed out that, as the microwave reaction time increases, the redox reaction between graphene and potassium permanganate can proceed more sufficiently, and MnO2 can deposit on graphene sheets much more uniformly as well, thereby facilitating a denser and more homogeneous microstructure in the graphene/MnO2 composites.

The prepared composite films had more homogeneous TiO2 dispersion with changing [ANI]:[p-TSA] molar ratios from 6 1 to 1 1.

Electrical measurement results and scanning electron micrographs show that once-extruded composites had a porous structure and poor conductivity while twice-extruded composites were much more homogeneous and had higher conductivity.