Sentence examples for molds were then from inspiring English sources

Molds were then centrifuged at 3,000 rpm during ~1 min to prevent air bubbles formation and hardener.

The PDMS molds were then applied to replicate some commercial polymer coatings at an elevated temperature of about 140 °C to transfer the mold pattern to the coatings.

The cylindrical molds were then put into the water in order to cure the ESC according to the pre-determined curing regime (Fig. 1).

The pressure was allowed to fall, and the molds were then immediately quenched into a large bath filled with water at 20 °C.

The cylindrical molds were then placed into the water bath at the reference temperature of T r (=20 °C in this study) for 3 h to allow the initial setting of HESC.

He carried out a very thorough examination and made a photographic record of all visible monuments, carried out some minor excavations, made paper and plaster molds of the hieroglyphic inscriptions and surveyed the principal sculptures; these molds were then shipped to the Victoria and Albert Museum, with casts being transferred to the British Museum.

Poly(dimethylsiloxane) (PDMS) production molds are then created using the master molds through elastomer molding.

The molds are then filled with white gold or one of roughly 30 alloys that Jostens uses.

The mold was then cut, yanked off the cube in pieces and reassembled.

The resulting negative mold was then used to cast secondly PDMS replicas.

The surfaces of molding are then identified based on the classifications of their geometrical entities.