Sentence examples for molding process and from inspiring English sources
The study investigated the influence of two kinds of gas foamers (CO2 and N2) on microcellular injection molding process, and the following processing parameters such as temperature, time, pressure and gas controlling were considered to research.
The fluidic structure of the valve was fabricated by polydimethylsiloxane (PDMS) replica molding process and sandwiched between two permanent magnets.
Finally, the effectiveness and merits of the proposed method are illustrated by application to an injection molding process and a batch reactor, in comparison with a typical PI-type direct ILC method recently developed.
Since there are many process parameters involved in an injection molding process, and more importantly, an optical lens needs precisely controlled surface contours, determination of the processing conditions for lens molding is very complicated.
The Pt Ir and Ni Ir film coatings are unable to withstand the working temperature over 1500 °C, which is considered for quartz molding process and hot embossing process.
The efficiency and merits of the proposed scheme is illustrated by an injection molding process, and results show that it can guarantee the stability and minimum running time whether the process is in normal operation or in case of actuator faults.
The fabrication of the developed migration-chip is based on simple photolithographic processes and replica-molding using a transparent elastomer as depicted in Figure 1.
As far as the manufacturing of CFRPs is concerned, liquid composite molding processes and autoclave techniques are highly temperature-sensitive.
Collider promises the ability to handle multiple materials with one machine, structural integrity on par with injection molding processes, and a smooth aesthetic.
DeSimone says it should be possible to incorporate active molecules into the molding process, though, and thereby create "artificial viruses" that can bind to cells and block real viruses from doing so.
In a paper [15], it is shown that the combination of RSM and GA proposed is useful for the optimization of injection molding process parameters and for minimizing the molding warpage.
