Sentence examples for molding consisting of from inspiring English sources

A device was designed to study compaction behavior and permeability of preforms in vacuum-assisted resin transfer molding, consisting of a pressure control module, a pressure test module, a thickness test module, and an experimental plate.

In bell founding, molten metal (usually bronze) is poured into a mold consisting of an inner core and outer mold or cope contoured to a bell's profile.

The purpose of this study was to introduce an improved customized mold consisting of 2 pieces to allow the fixation of molds to these sites.

The preparation of patterned silk fibroin mold, consisting of the drop-casting of silk fibroin solution and the formation of silk nanostructure film replicated from patterned PDMS film, was a simple and practical process.

To study the effect of the additional solvent treatment of the silane-coated master mold on PDMS molding, right before (undiluted) PDMS casting, some master molds were dipped into toluene or hexane for 1 min and dried with nitrogen gun. Figure 1 shows the scanning electron microscopy (SEM) image of the master mold consisting of array of holes with various diameters.

Using ZEP-520A and PMGI as the top and bottom layer resists, we fabricated an imprint mold consisting of 150-nm diameter pillars sitting on top of 1.5 μm wide ridges.

The interconnected pores, large enough to ensure an adequate vascularization and new tissue ingrowth, can be obtained by pouring a slurry containing a biodegradable thermogel (such as agarose and gellan) and a ceramic into a mold consisting of a three-dimensional network of rigid filaments.

Briefly, a negative polysulfone mold consisting of 5-mm diameter×10-mm long cylindrical prongs was constructed to fit into 6 wells of a 48-well plate (Costar, Corning, NY).

Si mold consisting of an array of nanopillars, with 130 nm diameters and 150 nm heights, was used.

To replicate ridges, a composite PDMS mold consisting of a thin layer of hard PDMS with relief features and a thick slab of soft PDMS was prepared.

The vegetative phase of these slime molds consists of amoeba-like cells (myxamoebas) that group together ultimately to form a fruiting (reproductive) structure.