Sentence examples for molar surface area from inspiring English sources

These effects should be attributed to partial molar surface area, surface tension and its temperature coefficient.

Thereinto, partial molar surface area and surface tension are the major influencing factors for Eo, Ko, ΔrGm and ΔrHm, partial molar surface area and temperature coefficient of surface tension are for (∂E/∂T p, ΔrSm and Qr,m.

It appeared that those cows with the lowest reduction in particle sizes by ingestive chewing were those with a smaller molar surface area.

For Au nanoparticles, as the radius exceeds 10 nm, the major factor is partial molar surface area, there exist linear relationships between the electrochemical thermodynamic quantities and reciprocal of radius.

Silica to alumina molar ratio, surface area and the number of strong acid sites increased on increasing the concentration of acid used for activation.

Fcad molar amount per surface area was twentyfive times higher on high-swelling compared to low-swelling films, but differences became smaller when large ALP (appr. 2 1) were employed.

The thermal stability and special surface areas as well as total pore volumes of the resulting polymers was enhanced with the increase of the molar ratio and the surface area reached up to 760 m2 g−1.

Using the analytical method from XRD, the crystal lattice in addition to the surface area, molar volume and the oxygen packing density have been estimated for the irradiated and un-irradiated samples.

Using the developed prediction expressions, the maximum values for Si to Al molar ratio, acidity, BET surface area, average pore size and pore volume were found to be 11.75 ± 1.19, 4.17 ± 0.47 mmol NH3/g, 739 ± 17 m20.7 20.7 ± 0.9 Å and 0.351 ± 0.008 cm3/g, respectively.

Sixty MOE-type descriptors can be computed from connection table information based on atomic contributions to Van der Waals surface area, LogP, molar refractivity, partial charge, and E-state value.

The ligand properties were calculated by the RDKit cheminformatics toolkit [54] and they include the logarithm of the octanol-water partition coefficient (logP), molar refractivity (SMR), topological polar surface area (TPSA), molecular weight, and number of rotatable bonds, hydrogen-bond donors, hydrogen-bond acceptors and aromatic rings.